Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed Win2K server at two locations. I have installed WINS on both with push/pull enabled. Why can't I see the remote server and other workstations and printers at the remote location.
7 replies
by stillatit
Did you reconfigure the remote server and other workstations at the remote location to use WINS?
Did you change the node type on every machine to "hybrid" so that they check WINS at all? (My guess is that this step got left out.)
Good luck.
Poster rated this answer
You also need to configure the workstations to use the WINS service under TCP/IP properties.
Try this to discard any other conectivity issue:
Start/run and then type \\IP_address_of_a_remote_machine
Poster rated this answer
Apparently, browsing over a router is not supported using a workgroup. A Domain must be set up for the browser to work. I installed ADS with a domain and now I can browse services on both sides.
Poster rated this answer
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
17 replies
0 helpful
5 replies
0 helpful
12 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies
0 helpful
2 replies