Discussion Locked

Burning smell then no reboot!!

0 helpful
21 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

To explain a little of the problem I have outlined chronologically what has happened:

1] The PC in question was bought Oct 2000.

2] It has recently been updated to Windows 2000 and Office XP.

3] The KEyboard changed from English UK to English US Default settings and when I tried to rectify this through the control panel, it would not call up any dialogue boxes.

4] MS Outlook XP came up with a error box asking for a detect and Repair.

5] Detect and repair was run through the HELPoption. WHen asked to shut down, we did.

6] On turning the PC back on an electrical wire burning smell came from the back of the PC and when trying to boot up the PC stops with an Invalid Boot Diskette Error A: and asks me for a valid one. There is no diskette in the computer.

I desparately need to get information off the hard drive. Is there any way through Set-up to get past this message? Does this mean a wire ahs burnt through and I will no longer be able to access my computer?

21 replies

by billc124

It sounds like something inside the computer is fried. Is there a warranty on it or is this just a clone. If it has a warranty, call the manufacturer and see what they say. If not, then you can always put that drive in another computer as a slave and access from the other PC's operating system. Your best bet is to put the drive in another Windows 2000 computer. You can then access the data and copy it to another drive, etc... If however, the burning smell was something getting fried, it could have ruined your hard drive, in which case you can't get anything back. If it were me, I would put the drive in another PC and see if you can access the data. If you don't know that much about computers, hire a technician to come and look at it, if the data is that important to you these are the steps I would take.

by dmiles

Form what you described it could be the power supply has burned out open the computer case and check the wires for any melting,check the wiring near the power switch also.Reads as though you have damaged the motherboard also.
Take the hard drive out of the computer and install in another computer to see if the drive will boot.If this does not work there is little else to be done to get the info off the drive,unless the data is important enough to use a data recovery vendor.

by netmare

My first thought is the data cable coming from your hard drive going to your motherboard. Invalid Boot Diskette Error A:
is common when the BIOS is unable to read the master hard drive. Try replacing/checking the data cable. If that doesn't work then you may have a problem with the motherboard, or the power supply wire going to your harddrive. I would send it back if at all possible. To get Information off of the drive slaving shouldn't be a problem as long as the drive wasn't damaged.

by ojmj

You didn't mention if this was a custom-built PC or factory made. There is one thing I would add to SoulRider's advice:

If this is a clone (or custom build,) it sounds to me like it could be in the Floppy/Hard Drive controller card. If you aren't going with the warranty repair, I would suggest that you do this:

Disconnect all power; make sure that any static build-up has been grounded; pull the cover off the computer and find the broad, flat wire that is connected to the hard drive. Follow that to the Hard/Floppy controller card, and remove that from the slot. Inspect this card visually to see if there are any scorch marks on it. If so, replace it. If not -- or if the broad, flat wire plugs directly into the mother board, you'll need to see where the scorching is located and replace whatever it is that needs to be replaced. Hopefully it won't be the hard drive.

Good luck.

O.J.

by billc124

In response to the last post. If this is a fairly new computer, you will not be able to remove the Hard/Floppy drive controller since in most of the PC's that I have seen lately have had these built onto the Motherboard.

by csmith

The burning smell is almost always the power supply regulator burning, or a short in the wiring of the power supply.
The boot error message is common. Another common error message is invalid ROM CheckSum.
These are false error messages cause by the out of tolerace voltages, which are caused br the failed regulator.
Fortunately it is cheap to replace the Power Supply.
Most of the time the PC will boot normally, after a new power supply is installed.
Regards, Chris

by csmith

The burning smell is almost always the power supply regulator burning, or a short in the wiring of the power supply.
The boot error message is common. Another common error message is invalid ROM CheckSum.
These are false error messages cause by the out of tolerace voltages, which are caused br the failed regulator.
Fortunately it is cheap to replace the Power Supply.
Most of the time the PC will boot normally, after a new power supply is installed.
Regards, Chris

by csmith

The burning smell is almost always the power supply regulator burning, or a short in the wiring of the power supply.
The boot error message is common. Another common error message is invalid ROM CheckSum.
These are false error messages cause by the out of tolerace voltages, which are caused br the failed regulator.
Fortunately it is cheap to replace the Power Supply.
Most of the time the PC will boot normally, after a new power supply is installed.
Regards, Chris

by >@ >@ gone fishing @< @<

I don't think it is the power supply, it would be unlikely to still boot. I beleive either one of the CHIPS on the Hard Drive has burnt out or the IDE controller on your board.

DON"T OPEN YOUR CASE IF IT IS IN WARRANTY. As a warranty tech I wouldbe forced to inform you, that you have INVALIDATED YOUR WARRANTY. If you call the company first and run it past them, they will be understanding, if you don't check you might not get warranty.

by diamond dan

Hi rebecca,

In addition to all of the previously mentioned advice (remove hd to another pc to get data, take note of any error messages at boot up), I have one more possibility.

If pin 34 on your floppy drive or floppy cable or floppy controller is bad, the system will not recognize that a new disk has been inserted (or removed) and will continue to show previous contents. If you are getting "Invalid Boot Diskette Error A: " and there is no disk in drive A:, it sounds like a pin 34 problem.

To remedy this, change the boot up sequence to C: A: instead of A: C:. This way you will look to the hard drive instead of the floppy on boot up.Additionally, try disabling your floppy drive in the system CMOS so that the pc does not even lookthere.

If this does not work, there is something more serious involved. As mentioned previously, do not remove the cover unless you are sure that you cannot claim warranty service. Also, if the power supply was bad, you would get no error messages at all, as the pc would not even start.

Best suggestion is to get your data to another machine and then take the 'smoker' to a qualified repair shop. Burning smell is always BAD, and always needs repair or replacement.

Good Luck,
dan

This discussion is closed to new replies.