5 replies
by xzar987 Accepted solution
by seanferd Accepted solution
Try installing the drivers you need for your system (actually, you can't, right?), but if the HAL isn't configured properly for your CPU, etc., you're pretty much boned without the proper installation media. The likely problem is that you don't have the correct controller drivers (among others) installed, so no boot device.
by xzar987 Accepted solution
by seanferd Accepted solution
But you will have to at least find the exact drivers for your drive controller and processor available on removable media to be inserted when you are offered to press F6 to install additional drivers.
However, you are probably looking at further trouble, at least with entering the installation key or validation.
by johnwright25 Accepted solution
Be sure the following components are in your configuration:
An IDE controller
The Primary IDE Channel component
The Secondary IDE Channel component
A disk drive component
Note Windows XP Embedded has three components that contain the name Disk Drive and three .inf files that identify their drivers with the name Disk Drive. To determine the generic disk drive component, you must inspect the properties of each component, and then select the one with the cmiPNPDevID property set to GenDisk.
If you created a configuration based on a Target Analyzer .pmq file, verify that the run-time image is installed on the same device. If it is installed on a different device, this error may occur due to missing drivers for critical devices.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending