Discussion Locked

Can I Have Two IP Addresses on one netwo

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi...I'm a junior net admin in a college.....i have an ipaddress from a DHCP....may i have two IP address on 1 network card..in NT ..or in LInux......how can i configure it....plz help

15 replies

by ebob

In NT, in the Network Control Panel, go to "Advanced" under the TCP/IP Protocol tab. You can add a 2nd and 3rd and... IP address to your system. Reboot required, of course.

by nettek

Answer 2 is correct. You can bind multiple IP addresses to one NIC card in NT. But only if you are using static addresses. It cannot be done if your NT machine is set up to request an IP address from a DHCP server.

by tomsal

Its quite simple actually to bind multiple addresses to a single NIC with Windows NT. However, as pointed out in a previous reply - you can't do with DHCP. You see DHCP assigns dynamic addresses and the DHCP server itself must have a STATIC address.Therefore, you can't (nor would it make much sense to use a DHCP in this way - regardless) assign multiple addresses to a single NIC using a DHCP server.

At least not with the "out of box" NT product.

I'm sure someone probably hacked out a utility to allow this though.

If you need help on binding static addresses to a single NIC, email me and I'll give you the info.

Take care.

by coscollu

Answer 2 is correct. You can have as much as five addresses in one card following the given procedure. If you want more than 5 addresses, you have to play with the registry. I think there is no limit when directly added to the registry.

by jman_diaz

Like the a few of the guys mentioned you can add multiple IP's to a NIC. You can also make reservations on the DHCP pool by using the NIC's mac address. Give it a try maybe it will work

good luck!

-JM

This discussion is closed to new replies.