Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have installed the modem, RAS, Point to Point Tunneling and I can not get any modem to work on any NT server in my environment. I am going nuts trying to figure this out. What am I missing?
7 replies
by doughayden
If it's a US Robotics modem, then there's a special program from USR you have to run to add it to your Control Panel.
Also, I don't believe that USR internal modems (especially Sportsters) are supported by MS.
I dealt with this mess a couple of years back, and the only way I got it to work was with the USR program
Good Luck!
by lheisey
Poster rated this answer
by nettek
Try installing the modem as a Standard 288000 kbs modem. If you're worried about the 28.8 speed, NT RAS won't operate faster than that anyway.
by lheisey
Poster rated this answer
by rfraysier
Is this an ISA modem? If so you may need to install the PNPISA.inf file for NT to recognize it. This file is located under the i386\drvlib\pnpisa right click on the file and choose install, reboot and see if NT will detect it now.
by lheisey
Poster rated this answer
by lheisey
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
20 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies