Discussion Locked

Can't boot with IDE primary master and primary slave hard drives attached.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here is my problem. I am running WinXP Pro and have twohard drives connected to my primary IDE channel. I have an ASUS A7V400MX motherboard and 2 gigs of ram.

I was running 2 80 Gig Western digital hard drives. I use my 2nd drive to Ghost to. My system has been very stable for over 4 years.

Last week I ran the WD diagnostics on both drives and found out that my primary drive was good and my second drive would not pass the tests.

I them purchased a WD 160 Gig drive to replace my 2nd drive.
I installed it as primary slave and formatted it to NTFS. Everything fine so far. I then used Ghost 2003 to do a sector to sector copy of my C drive to my new D drive. I then made my new drive primary with no slave attached. Everything was great it booted up and I was on my way.

Here's where the problems started. I then installed my old 80 Gig drive as primary slave so I could use it to Ghost to for a system backup.

Now I can't boot with the Primary slave attached. I have spent the last 2 days talking to Tier 2 support at WD. Basically they have given up. We tried may potential solutions including Win Recovery Console, writing 1's and 0's to the slave drive, I updated my bios to the latest version, etc.

Any help would be greatly appreciated.

I thank you in advance.

BZ

5 replies

by santeewelding

Is so much easier than the larger things.

Same with me. Only, it's laundry. When I do my laundry, I am in control.

I think.

This discussion is closed to new replies.