Discussion Locked

Can't change ip address w/ Active Dir.

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a server installed with Windows 2000 Adv. Server. I gave it an ip address of 192.168.0.11. I then ran DCPROMO and installed Active Directory. I need to switch the ip address to 192.168.1.11. When I do it causes Act. Dir. to stop functioning until I change ip address back to original. How do I get around this?

11 replies

by haig

When you change the IP address, the DNS records that allow your clients to locate resources in AD become inaccurate.

You _should_ be able to resolve this by;

A. Making sure that you are pointing to the correct DNS server
AND
B. Restartingthe NetLogon service.
Restarting the service will re-register AD related records in DNS.

by bradq

The AD stops functioning on the Domain Controller that it is installed on. At this point there are no workstations connecting it it. I can open DNS Manager but which properties do I change?

by klbingeman

I read a document a while back when someone did this as well.

You have to run dcpromo to remove active directory from that server, change the ip and re-install active directory.

Now if this is a root server - it will kill your entire forest. Not a good idea. If this is just a domain controller, make sure you transfer all FSMO roles to other domain controllers first, then proceed.

Good luck..

by bradq

This is the only Domain Controller so it is the root server. I'm just stuck then unless I removed AD and start over?

by haig

It really doesn't have to be hard. Take my word for it.

Does the DC have itself configured as its Primary DNS Server? If so, this will be really easy.

1 Change the IP address.
2 Get into Administrative tools, Services
3 Right click on the NetLogon Service and choose 'Restart'

Now, something that is not mentioned here is that your clients will need IP addresses that fall into the 192.168.1.x range...

Good Luck

by bradq

Yes, the server is configured as the DNS Server. There are no other DC's or workstations on the network. I want to get this issue solved before I start adding workstations. I tried what you said. I switched IP address, stopped and started the Netlogon Service and it still says AD is not functioning and the site has a red X on it until you switch back to original IP address. There has to be some DNS settings that need to be changed as well but I dont know which ones.

by arg cio

Temporary fix....

Try binding the second IP address to the server, under IP Properties Advanced. This will allow you to work with the 192.168.1.11.. if that works.. then edit the registry to change all the references to 192.168.0.11 to the new IP.. good luck

by bradq

The ip addresses arent so easy to change in the registry. They have dots everywhere and are in columns.

by jaystar

From a command line, type nslookup
type ls -d

that will list all records in DNS concerning your domain.
Look for your server IP in those records. Write down the names that corespond to your old IP.

Start DNS via the Administrative tools.
Open your server
Go into Forward Looking Zones
Open your DNS Name Space of Active Directory.
_msdcs has a sub folder named gc
You will need to change that entry and the entries in your DNS Name Space that show your old IP.

At that point, I would reboot to assure everything was updated and started in the correct order.

Good Luck,

Jay

This discussion is closed to new replies.