Discussion Locked

Can't find shared printer using RAS

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have an employee that dials into our server using RAS. She has Microsoft printer and file sharing turned on, and has her printer shared. We have the RAS dialin set to give a specific IP address at connection. Once connected we can PING her machine but are unable to find the IP address under START/FIND/COMPUTERS and are also unable to to use the NET USE command to assign an LPT port to her printer. We uninstalled and reinstalled the printer as well as turned off and back on printer sharing. With all of this we still can't map her printer. When I run WINIPCFG on her machine I see she is using the subnet mask of 255.0.0.0 when we use 255.255.255.0. I can't find a place to set that under dialup networking (I'm not sure it matters). Any help would be appreciated. P.S.-when I turned Windows printer sharing off on her computer, it didn't ask for the CD when re-installing. Is there a way to remove it completely so that I can reinstall it off the CD?

5 replies

by stillatit

File sharing and ping use different name resolution methods.

Can you connect to her machine if you use her ip number, e.g., \\192.168.0.42 ?

You will not see her computer name in browing until her machine gets into the browse list, which may be never. She should have an lmhosts entry for your BDC or PDC with the #PRE and #DOM: tags. If her workgroup name is the same as your domain, she should show up in your browse list eventually.

If you put an entry in lmhosts on your machine for her IP and name, with a #PRE tag, you should be able to find her by name any time she is online.

On the mask issue, there should be a place for mask in the dial-up entry where she requests her specific IP address. The mask will be a problem if it prevents distinguishing her network segment from yours.

Printer sharing is not the issue, and reinstalling it will not help.

Good luck.

by stillatit

If you can ping but not connect with an IP number, you need to look at the connection characteristics, because your SMB messages are not getting through. You can test this in that the remote station probably cannot map a printer on the network side either.

1. On the client side, is NETBEUI bound to your dial-up adaptor? (It should be.)

2. On the client side, in the dial-up entry being used, is the NETBEUI protocol turned on? (It should be.)

3. On the network side, on the RAS server, isNETBEUI turned on in the RAS properties for incoming connections? (It should be.)

4. On the RAS server, is the incoming connection set to connect to the entire network? (It should be.)

5. On the network side, where is the default gateway pointed on the box trying to access the remote station's printer? If the device at the default gateway address is not the RAS server, how will traffic be routed to the RAS server?

6. Have you resolved the mask issue? If the user's mask is different from yours, things will not work properly.

Good luck.

by shedler

Since we were connecting to a server that was not ours, we were unable to set the RAS server to NETBEUI because their IS Manager wouldn't allow the extra line traffic that NETBEUI causes. We set the subnet mask but once connected it would default back to 255.0.0.0. We ended up unistalling all of the modem drivers, the modem, the dialup networking adapters, and then reloading them. We then starting adding the settings back one at a time and rebooting. After all that, it just worked. Thanks for the help.

This discussion is closed to new replies.