Discussion Locked

Can't find WIN.COM

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
At boot up I get a message in DOS that it can't find WIN.COM. When I change directory to C:/windows, and key WIN.com and Enter, Windows starts up. How do I fix it so Windows starts by it's self? I am using Win98.

10 replies

by a h

Open MSdos.sys (you can find it at the root)in Notepad
and make sure you have these lines in msdos.sys

[Paths]
WinDir=C:\WINDOWS
WinBootDir=C:\WINDOWS
HostWinBootDrv=C

then Open autoexec.bat and add these lines

SET windir=C:\WINDOWS
SET winbootdir=C:\WINDOWS

restart windows and it will autostart

Good Luck

by otl

At bootup type path

If Path <> c:\;c:\windows

Type path = C:\;c:\windows;c:\windows\command

Type edit autoexec.bat

hit a return on any line and add;

path = C:\;c:\windows;c:\windows\command

alt+f to enter task bar

save file and exit

reboot

should work
Good Luck !

by otl

This will also give you the DOS equivilant of Notepad (edit) in DOS.

by mplatts

This can sometimes happen if you have path statements that are too long. Rem out some of your path statements to see if this clears up your problem. If so, check for duplications in the paths and remove them.

by engineer

I had the same problem and found it was caused by installing the win98 Resource Kit.
It places the following line in the first line of the Autoexec.bat file: "@PATH C:\PROGRA~1\WIN98RK;%PATH%".

Rem this out or remove it.

I uninstalled win98RK but this did not fix the probelm. I did not reinstall it so I'm not sure if the uninstall is needed. You would most likely have to build a path statement that included the path to win98RK but that path statemnt would also need to be pointed at C:\windows too.

This discussion is closed to new replies.