Discussion Locked
0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have covered everything mentioned in a recent Daily Drill Down covering this topic. I have an external modem which Windows will not detect. (Windows 98 will detect it when installing it.) But when testing it or trying to dial out, Windows cannotdetect the modem. I have tried different cables, and even bought a new external modem to no avail. I have checked all the software settings and everything appears OK. There are no hardware conflicts. In modem properties, it says that the modem is located on COM 2 and when I try the diagnostics on it, it can not detect it. I have used msconfig and unchecked most of the items, and retried it, No luck. How likely is it that my original & my newly purchased modem are both bad?
11 replies
by grump
OK, First lets keep it simple..
Have you check to see if the com port that
the modem is connected to actually is a
working port?
Get back to me...
by tcarls
Poster rated this answer
I am not too familiar with external modems, however I had the same problem with an internal modem and had to reinstall Windows 98 over itself in order to get it to work. I don't know if this will help in your case or not but it may be worth a try.
by tcarls
Poster rated this answer
by j003
I would unistall and reinstall. or change the comm port, it sounds like a conflict.
let me know.
by tcarls
Poster rated this answer
by air2air
I've run into similar problems with other external devices. Sometimes Windows will recognize the hardware, even though the port in the CMOS/Bios is turned off or not configured right. Check to see if it is turned on in CMOS, if it is but is in an auto mode, switch to a hard setting. The last ditch is to reset the CMOS to original configuration then configure anything that has changed. Also, if it is a Dell, try the "trick" reset. While in the CMOS, turn on the Num Lock, Caps Lock and Scroll Lock. Hold down either the Ctl or Alt key (can't remember which for sure) and hit the E key. You should hear a beep (one). Then while holding the Ctl or Alt hit the F key. You should get another beep. According to Dell this clears the CMOS of any garbage. It solved several problems where I though the motherboard was whacked.
by tcarls
Poster rated this answer
by tcarls
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
0 helpful
1 reply
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies