Discussion Locked

Can't Load any Operating System

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My son deleted a bunch of "stuff" from his hard drive and now when I try to reload any OS,I can load up to the point I need a CD. At that point I'm kicked out because the OS can't read from the E: drive. Even when using NT Workstation I get thru disk 3 but when I put the CD in I get kicked out. I've used FDisk, reformated the c: drive and attempted to load Win 3.11, Win 98, Win 98 SE and Win NT Workstation. Any suggestions?

11 replies

by straci

I don't think you have to load WIN 3.11, WIN 98 or SE. I will try loading DOS 6.22 then a CD driver. Run scandisk to see if you have a bad sector. After that change the Boot-up setting from A:\ to CD. Load WIN NT this should work. It have for me 70% of the time.

by dmiles

If you have a WIN98 startup disk insert in floppy and boot computer,select to run setup with cdrom support,win98 start up disk will have generic cd drivers to get the system up and running.
Boot the computer and use the key to open the CMOS controlpanel and make sure the configuration to cdrom is listed.

by bohicam1

NT workstation is bootable from the cdrom. Try just sticking in the cd and booting from that. If that won't work then I would check 2 things.
First, make sure that in the CMOS, that the cdrom is one of your boot options, second, make sure the cables to the cdrom device are actually connected properly. The IDE ribbon cable has the red stripe towards the power cable and the power cable has the red wire closest to the IDE cable.
Since you did ahve win98 on the hard drive, is there any chance that one of your drives or partitions were formatted as FAT32?
Get rid of that too.

Good luck!

Mike

by william jay

Use the boot disk from win98se, start with cdrom support, copy any needed files to a directory on the Hard Drive and away you go. By the way, winnt.exe and winnt32.exe are the setup programs for NT in dos install mode ... use the /? switch to see the options.

by donmars

Go to the website for the manufacturer of your hard drive and get a "Low Level Format" utility. You can get one at various websites if you do a search for low level format utility, but you will need the name and model of your drive because low levelformating is "drive specific". be sure to get the documentation for the program and all the specifications you can get about your drive. The program will ask you for some of these specs (numbers). This procedure is somewhat technical but I am sure it will work for you and cheaper than a new drive. after you low level format the drive then do a dos format and you will be good to go.

This discussion is closed to new replies.