Discussion Locked

Can't see NT 4 server in net. neigbourho

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have and NT 4 server on my domain that is not visible in network neighborhood/my network places. I can map to it, I can PC anywhere to it, but that is the only way I can see it.
All network settings seem to be in order.
Any suggestions would be appreciated.

9 replies

by mckaytech

There is a registry key that can be set to hide the server. The last time this came up, I found it that key by searching the registry using "hidden". Unfortunately, I don't remember now exactly where the key was but I know the issue has come up onthis forum a time or two so a search of the archives might be worthwhile if the registry search doesn't pay off.

paul

by taiseermustafa

Just to add,
If you can ping it by address and can't ping it by name then, please check the WINS, and check that it is correct.

Good Luck

by astrid

This may be totally useless. I worked on a clients system that when installing NT workstation, That when it asked for the Domain controller I could not find it and had to install the machine as a workgroup machine not a Domain Member. The server ran Netbui protocal so I installed netbui on the workstation and found the server. I am pretty sure it was the switch that for some reason would not allow me to resolve the machine name. As I could ping the machine but could not see it. We have since replaced the switch and have not had to move or rebuild a machine that connected was connected to that switch.

This discussion is closed to new replies.