9 replies
First: Do not hook CDR on same cable as hardrive. This will cause buffer overruns.
Second: After making this change, remove all software pertaining to the CDR. If you are running Win98, remove all references to mscdex on your config and autoexec files. You do not need them.
Third: Shut down and reboot. Make sure that Win can see and access your CD.
Fourth: Reinstall your burner software.
This should solve your problem.
If you are running ME, Good luck at find a burning software that will work. Adaptec under 4.0 will not, Nero will work spottedly.
by bupham
by smokey
There are three things I always do for cd-rw's.
1. Put the cd-rw on the master secondary ide channel.
2. Install the correct drivers.
3. Make sure the software you are using supports the cd-rw you bought. Off brands are hardly supported.
This should fix your problems. Also, you don't always get buffer underruns when you have the cd-r attached to the hard drive channel. All you need to do is make sure the cd-r is the master. Don't slave it to the master hard drive that runs windows.
by bupham
by kdurichek
The other guys or girls are right about checking that stuff, but I had one the other day at work that would not work by the instructions. It would hang up every time. The only way I could get it to work was by doing directcd (dragging and dropping).Don't know if it will work on yours, but it's worth a shot if other things don't work.
Allen
by bupham
by otl
by bupham
by bupham
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending