Discussion Locked

CDROM Missing in Devices

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Creative 5X PC-DVD Dxr2 DVD Rom installed. The drivers for the DVD show up in the Sound, Video and Game Controllers system devices but the CDROM does not show up in the system devices. Therefore I do not have use of the CD/DVD drive. I believe this might be a resource problem but I don't know where to go to resolve it. The DVD is chained with a Seagate tape drive on the same IDE and the dual hard drives are chained on a separate IDE. The DVD is designed as a master.

9 replies

by saihib

Try changing your configuration around. For example set your second hard drive as master on the secondary IDE channel with the DVD as a primary slave.

by parbo

An easy step to confirm that your hardware is ok is to boot and watch the POST to see if all drives are recognized orr check in the BIOS. If so boot with for instance a W98 bootdisk and see if you can access the cdrom from DOS. If so you know your HW is ok so you start looking in windows now. If you're running w95 you might need the Bus Mastering drivers PIIX3 or 4. If you need those drivers your IDE controllers wont read DUAL FIFO in the device manager. If you have win98 that's already loaded for you. You could remove the PCI bus and reboot but usually that leaves you loading all your drivers again. But its an effective way of having your devices being redetected

by fenaikh

Hi
For you qustion about resource problem :
To find any resource problem in win98 you shoud run start->run-> sysinfo32.exe
this utility will give all kind of information you need.Just click the + under each catagorey to see more info.
To check for CD/DVD drive:
There are many reasons please follow these steps:
1- First of all The BIOS should see it first
make sure second IDE is enabled on The BIOS then in POST watch for it).
2-Check for lights on the CD/DVD drive if no lights then check cables for loose connection (data and power, it could be cable problem) else check for master salve setting is correct.
3-Make sure your motherboard drivers is installed.Then check IDE for a yellow ? mark in the system device.
If there is a yellow mark then check if there any code in property)
1)If in the preformance any message that says you have A DOS compatiblity mode.This happen if in the registry a Subkey "NOIDE =1" then delete else You have a virus kill it by booting with a clean flopy and a good virus killer.
Notes.
1-Please always tell about your OS and mother board if possible to see if there any problem with them and your device.

please do these if you need any help please send a an E-mail to me.
Best regard
Mohamed
fenaikh@hotmail

by pastor.marc

I have encountered several viruses in the past that use the memory location for the CD-Rom therefore causing the CD not to show up in Windows...
Give it a shot in the arm by updating your anti-virus and scanning your system.

This discussion is closed to new replies.