Discussion Locked

CDROM reconized by win but doesn't read

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a gateway 400 celeron with a standard CDROM. The drive is recognized by windows but will not read any disks. I get the "drive not ready" dialog box every time I try. I have reinstalled the drivers(in both DOS and WIN). Checked cables for security and connection. The drive is autodetected by the CMOS. I have a suspision that the drive is shot but would like a second opinion. The drive does not seem to be spinning.

11 replies

by mm212

I would agree. It sounds like the drive is shot. One thing I would try first, though is to replace the IDE cable and try again. If you get the same results, it's time to get a new CD-ROM drive.

by admin-stuart

Also, remove the drive and install it in another PC. If the first post and this one both don't help, then I agree, bad drive.

by tlippert

Use a boot disk with cdrom support. If you can read files on the cd then it is a windows issue. If you can't read files it is a dead cd.

by shuja52

Whether your CDROM drive that is E or D or the case me be is seen in your Explorer or in control pane? If the answer is no, open your config.sys file and write lastdrive=D or lastdrive=E as required

by pcarnaldo

Try opening the CR-ROM drive. I fixed a drive last week which has a chip of a CD stucked. Also, try cleaning it with a soft brush (like that from a make up kit), it's better to clean it manually than using conventional cd cleaners.

This discussion is closed to new replies.