Question Locked

Changed my Asus A8V deluxe MB, now i have hard drive problems?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

my old MB died, so i got another, but the computer would not boot up, so thought i would have to re install windows xp as the bios obviously does`nt recognise the new board.

i have formatted the maxtor ata HDD and re done the partion with `seatools`.

But still when you put the windows disk in and let it run up to installing win xp, it says it cannot see a HDD?

What please do i need to do?

is it serial ata drivers?

5 replies

by drivers1492

If Im thinking of the right board it has a variety of settings in bios to consider. The cd that came with the board should have the correct drivers to use with your windows install. Another consideration is the jumpers for your sata config either 3.0 or 1.5 dependent on the drive your using. Your info with the new board should let you know what settings to use and drivers you will need to load. Also a lil google will show you numerous responses and solutions to this exact problem to help you along as well.

by arabianjules

just tried to install win xp again, this time selecting F6 when it asks to add/install my own sata disk on floppy, i new it was there for a reason, which it does, wow thought i was onto a winner here..

..windows installs theses after formatting the drive etc...

then goes back to its win xp install page and still comes up with `cannot see HDD`!!

Lord help me!

think i might get another HDD :((

by tintoman

The drivers you are loading are not the right ones for the hdd you have

by tintoman

Is a wholly incorrect statement since the bios chip is located on the motherboard it isn't really possible that it wouldn't recognise the motherboard it is attached to.
Anyway that isn't the problem you have, you will need to create a driver disk for your hard drive SATA drivers. You can do that if you can download the floppy drive files from the manufacturer's website.
Then you will need to press the F6 key during the Windows installation set up when the message appears at the bottom of the screen saying "press F6 if you want to install 3rd party drivers"

This discussion is closed to new replies.