Discussion Locked

Cisco 675 w/dhcp NO Net Neighborhood

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The problem, I cannot use network neighborhood. No workstations or resources visible. ?Brows Master? settings have been adjusted properly. This is the setup?. I am working with a workgroup environment using Cisco 675 DSL modem running DHCP for Internet connection sharing. I am using the 10. Addressing scheme. I can ping all workstations from the router. I can ping workstations to workstations. The Internet is accessible from all workstations. They are connected through a single hub.
Does anyone know why network neighborhood is not functioning? This problem is occurring on three separate environments. I have a solution currently (Use NAT instead of DHCP) but I would like to be able to complete these projects properly.

7 replies

by stillatit

It sounds like you have not turned on Microsoft networking.

All stations should be set up to include netbeui and Microsoft client. This will enable the network broadcasts that the browser uses.

If you have a server somewhere on your network, set it up as a WINS server, and point all of the other stations at it. (TCP/IP properties, WINS address). The WINS server will keep track of all stations for you. This will allow you to browse across routers.

Good luck.

by tuqan

Check the policy editor on the three units that are giving you problems. If you have installed all the necessary and essential protocols (NETBEUI) then you should be able to view workstations through Network Neighborhood if it has not been disabledvia the policy editor on the units in question. I would look for Restrictions there. Hope it helps.

by compute2u

Because you use the term I CANNOT, i'll assume that only your workstation can't see the network. If that's the case, go under control panel>network, find the tcp/ip line and double-click on it. Click on all seven tabs without making changes, then click ok. If you don't have the cab files on your computer expect for it to ask for windows. it will verify/change the install, and reboot the computer.

This discussion is closed to new replies.