4 replies
by btyler02 Accepted solution
by sue t Accepted solution
by w2ktechman Accepted solution
there is either a problem with the drive, or it has incorrect jumper settings for use.
make sure that the pins are set correctly, and that it is in the MASTER position on the cable.
The BIOS might see it if set incorrectly, but the system cannot use the device.
by gill Accepted solution
2 pronged answer:
1)
If you are on a network...
And you have mapped drives...
It may be a drive letter conflict. Try "Q"
2)
Did you reinstall without the secondary HDD hooked up in the machine? Then shut down, opened case, hooked up, and rebooted? This is the preferred method. If drive worked before, it should again WITHOUT changing a darn thing, right? Think about it. Worked before... why should you have to change ANYTHING NOW!? If all else fails, unplug, unhook 2nd HDD, reinstall; shut down, power off, hook-up 2nd HDD, boot, let XP detect.
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending