Discussion Locked

Cloning a Compaq hard drive

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have attempted to clone a hard drive on a Compaq 1560DM notebook. During cloning, I noticed that the first partition is a "diag" partition, and then it shows 2 other partitions.

After the cloning and the installation of the new hard drive iscomplete, the notebook will not recognize the operating system.

Does anyone have some advice for me on this matter? Your help will be greatly appriciated.

Thank you.

9 replies

by rachel_s

Generally all compaqs have the DIAG partition if you install the ROMPAQ files.
This should not cause any problems in the image, but I would check for a couple things:
1. FDISK, make sure the correct parition is 'Active'
2. Since it is using theROMPAQ these machines would need to have to be identical. You may want to download an install the ROMPAQ on this machine also just to make sure.

Without an error message it is hard to offer many more suggestions...let us know what errors you aregetting during bootup.

BTW you can enter the Compaq DIAGNOSTICS by pressing F10 when the cursor is blinking in the top right hand corner.

by drew_lgca

The small partition was your bios. You might be able to download the bios from compaq and install it. You also might call compaq. Their tech support is pretty good overall. (800) 888-0287 this is the number I use to contact them.

by dark force

What OS is on your laptop?
I am assuming it is NT. Check your partition type, is it FAT16 or FAT32. I had this happen using Norton's Ghost, it automatically converted the FAT16 partition to FAT32 and NT had a fit.
Check the settings of your cloning software, it may be set to convert FAT16 to FAT32. Try it again.

Good Luck
JR

by jwilczyn

If you can try to use the Ghost program. Copy disk to disk. Install this new HD and detect it in the Bios.

This discussion is closed to new replies.