Discussion Locked

cloning windows nt 4.0

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to use norton ghost 2001 to clone windows nt 4.0 but no luck. I connected the clone drive and try to use disk to dsik but the clone HD does not show up. Can you clone windows nt 40 and if how?

11 replies

by mgonzales

We have done that...but we used drive image pro....we had problems with Ghost..I think you can download a demo from Power Quest.

Good Luck!

by vpon

Did you setup the master and slave settings correctly? Try setting the HD being copied as the master. Bootup to dos and then run the ghost.exe. Make sure that when prompted you choose the correct source and destination drives. I've had no problems ghosting an NT machine.

by time

Answer 2 states correctly, master / slave config must be right, also if it is a scsi controller in some cases you must set the driver.

by Former member

I've been doing a lot of Norton 2001 ghosting lately. Add the second drive just as you would normally and set up up in disk admin so the system sees it and has a drive letter. Install Norton and make your boot floppy from the boot wizard. Boot your system up on the floppy and if disk to image doesn't fly (their touchy sometimes) go from partion to image and you should see in either case the drive you want to use as a home for your clone.

by top_banana

Ive had a couple of problems using Ghost 2001 and NT4, but not disk to disk.
My resolution was to revert back to Ghost 6 and use -NTIL -NTIC switches on the command line.

I just thought Id add my experience to the discussion.

This discussion is closed to new replies.