Discussion Locked

CMOS Setup changes

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I read the article from Ken Dwight on Basic BIOS settings, part 1. THere is a part that states that if you have an operating system different from WIN 95 or 98, the drive translation should be Large or Normal, not LBA. I have WIN PRO 2k and it was set on LBA. I changed it and when it re-boot, it crashed. It goes as far as the initial name of the board and CPU name and it crashes. The keyboard doesn't work. I even changed the keyboard. I changed the HD and still nothing. It was set to second boot from the CD-ROM and that doesn't work. The keyboard lights up at the initial stages and then crashes. What is a next suggestion?

9 replies

by geroxx

I would say that you got burned. Break back into BIOS by hitting the crap our of the delete key go in a change the setting back. If that does not work you will need to reset you BIOS. Most MB's have a jumpersetting that will default you BIOS. Find the manual for your MB and default you BIOS if you can't get into BIOS the normal way.

Was your WIN PRO 2K working ok before you changed your BIOS? If so... the Mr. Dwight was either wrong or misunderstood. I have found it good advice that "IF it AIN'T broke... DON'T FIX IT!"

HtH
Gary

by jdfcomputer

LBA mode works fine with Win95/98/2000 and ME. However with DOS/Linux/etc... Large or Normal should be used.

by csmith

Once the Partition is set, it has the L, N ,or LBA written in the boot track.(Taken from the BIOS setting)
Change the BIOS back to its original LBA setting.
The choice can only be made on a new disk.
Later changes cause the problem you experienced.
Regards, Chris

This discussion is closed to new replies.