Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can you re-direct windows to recognize the mouse on com port 2:? The com ports are enabled in the Bios and are recognized as com1 & com2, but Windows 98 recognizes them as com2 & com3. So Windows does not recognize a mouse as being attached.
5 replies
by parbo
There are switches that you have to specify in the boot.ini right after the win2k line.
/FASTDETECT =[COMx | COMx,y,z...]
Turns off serial and bus mouse detection in NTDETECT. Use this switch if you have a component other than a mouse attached to a serial port during the startup process. If you use /FASTDETECT without specifying a communications port, serial mouse detection is disabled on all communications ports.
by mark.wolter
This is Windows 98 not Win2K.
by mark.wolter
Point value changed by question poster.
by mark.wolter
Point value changed by question poster.
by mark.wolter
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
17 replies
0 helpful
5 replies
0 helpful
12 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
14 replies
0 helpful
2 replies