Discussion Locked

Computer Help Desk Staffing

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am looking for a standard on the ratio of help desk staff to users. We not only provide telephone assistance but hardware installation and setup, traveling assistance to 70+ locations throughout Wyoming. We also have 1125 users on two separate networks: a 250 user peer-to-peer and the remainder on a WAN with dedicated local servers in 30 sites. I know I need more staff, but don't know how to gauge the true need.

7 replies

by jimhm

If you break up your helpdesk support - to Help Desk - Desktop Support and Network Support. It's a little simpler.

Our help desk folks are level 1 support - we try to keep a 1,000 to 1 staffing ratio (we have 10 to 15) working hours and 2 staffing on off shifts (this will vary depending on your converage requirements)

Desktop support (Hardware installs, break fix, and software installation) we attempt to keep a 250 to 1 staffing rtio.

Network support (voice, data, video) we attempt tokeep 250 to 1 ratio.

Hope that helps - we use push technologies for software distribution which - has reduced the size of the desktop support!

by jimbb

The previous answer is pretty good, but to get an accurate idea you need to provide more info. For example, a pure Mircosoft network generally needs more IT staff, and more helpdesk staff, than a NetWare network (I know of a company that has 1000 users throughout several countries in Europe, and the entire IT staff, excluded developers, is 4 people - don't let your boss read this ;-)). And further, and this is the most important, it all depends on the quality you intend to give. Response times, solution times, queueing times, will you support a limited list of applications/hardware or not... These things may give you any requirement from 100/1 to 300/1 for general helpdesk, and somewhat higher (like 400-500/1) for pure hardware, again depending on the quality. Are replacement parts at hand? Are spare PCs ready?
So, you'll have to talk to some department managers and so, before you really can answer that question.

Jim

by lynn.morgan

There are standard call centre algorithms based on queueing theory to calculate number of agents required. The best one is Erlang C.
To do the calculation, though, you need to know a few statistics first.
1) what is the service level you want to provide e.g. X percentage of all calls answered within y seconds (i.e., 90% within 15 seconds)
2) half hourly call volumes
3) average handling time
4) service level percentage

With this information, you can plug the numbers into the equationand it will tell you how many agents are needed for the level of service you want to provide.

This discussion is closed to new replies.