Discussion Locked

computer to computer network

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I are trying to connect a winpro computer to another winpro computer via an ethernet connection without using the internet. I created a workgroup on both computers but they wont communicate with each other. Any suggestions?

2 replies

by abu_danny

Hi,
I assume you have them both on the same IP network and subnet. You will need to
make sure that if you are connecting one PC to another with no hub in between,
you are using a Cross Over cable, if you are using a hub or switc than use Staight
cable.
Too often, cabling is the problem.
You can also add NetBeui into your protocols, it would make it faster.

Hope this helps

This discussion is closed to new replies.