Discussion Locked

Config. IE for Internet access w/Router

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Wich configuration settings are needed for having MS IE 5.5 to connect to the Internet using an ISDN Hub Router? So far, the only application that connects (and all by itself) it's the MS Messenger, that detects the connection type automaticly. So far, the IE wizard it's unable to detect the settings by itself, nor the manual configuration of IE had been successfull.

8 replies

by jimbb

Depending a bit on your ISP, I would make your ISDN box the default gateway, and use your ISP's DNS server(s). And in IE you can fill in your ISP's proxy settings, if there are any. Otherwise nothing.

Jim

by curlergirl

On the workstation's TCP/IP settings, set the default gateway to be the router's local IP address (on the local subnet, not the external one, if they're different). Also, put the ISP's primary and secondary DNS server addresses in the workstation's TCP/IP DNS settings. Then, in IE, on the Connections tab, make sure you select "never dial a connection" (just in case the workstation has some kind of dial-up connection set up), and, depending upon your version of IE, either select the "connect through my LAN" or click the "automatically detect" setting under the LAN Settings. This should do it for you. Hope this helps!

by curlergirl

Another tip - if your ISP doesn't use any kind of proxy, then leave the "automatically detect" box BLANK - don't check anything on the LAN Settings. Sometimes IE gets confused if you check this box and there isn't any proxy.

by marcovega

I found this comments the most accurated and helpful. Due this recomendations, the tech support dept of the router manufacturer was able to pin down an error in their recommended configuration. Thank you.

by matric

I find all you need to do is go go into Internet Explorer Options. Click the Connections Tab and select LAN Settings. Click on Automatically Detect Settings. You should then have no problems. If that fails go into MSN Messenger and go to options. Again go to the Connections Tab and copy down all settings in there. Now transfer them to IE 5.5

This discussion is closed to new replies.