Discussion Locked

configuration doesnot get saved to flash on cisco asa 5510

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have a cisco asa 5510 firewall, when i configure the interface and any other configuration and save with either wrie memory or copy run start and reboot the device all configurations disappears.

i need help

1 reply

by mafergus

Without knowing if this device is stand-alone or not, I would start there. THen I'd check to ensure the unit was up to the latest firmware.

This discussion is closed to new replies.