Question Locked

Configuring USB Wi-Fi Adaptor but LAN error comes up???????

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I bought a USB adaptor for my PC got it set up and was fine until my pc froze and it broke so I bought a second one, same make, model etc, but now it won't work.

It recognises there is a network available to connect to but won't connect to it. The is also an icon that comes up saying that the LAN cable is uplugged? I have no recollection of this happening before, and as it is a USB device there is no cable? Is this what is causing a failure to connect? I am using Windows 2000 and have so far failed to come up with a solution.

And yes i have uninstalled and reinstalled the drivers etc.

Any suggestions advice would be helpful cheers

3 replies

by fregeus

What make and model is your USB device?

When you un-installed the drivers, did you reboot before re-installing?

Have you looked at the FAQ of the manufacturer?

by davemarriage

Under control panel, then admin tools, go to services and make sure that at the bottom the wireless zero service has been started. Don't know if that will help or not....

This discussion is closed to new replies.