10 replies
by ann777
COM1 on IRQ 4 usually uses that address.
Check your computer BIOS for COM1 and COM2 settings; set it back to default; test again
or -
Remove the modem from the systemboard and see if you can setup Win98 then.
You may have a bad modemport or bad modem.
by csmith
The MODEM and the Mouse are fighting it out.
The "industry standard" is
Mouse is COM1, IRQ4, I/O 03F8h
MODEM is COM2, IRQ3, I/O 02F8h
Pull the MODEM out temporarily, set up the PC, then, add the MODEM and let plug and play configure it.
If the MODEM is Plug and Pray, you can also go into Device Manager, and manually force it to use COM2, if all else fails.
Regards, Chris
by acedan
by hrhold1
If you haven't solved this problem yet, go to :Start/settings/controlPanel/System...
Click on the device manager tab, and see which peripheral has the yellow exclamation or red 'x' on it. You can highlight the device, click properties, resourses, and possibly "change" the resourse that is causing the conflict, by highlighting the item causing the conflict with the "basic configuration 0000, 0001, 0002 etc....
You can also run "Add New Hardware" wizard to resolve comm port conflicts with a modem/serial port, if the OS has trouble allocating the necessary requirements to the device.
If it is a modem or port device causing the conflict you can 'remove' it from the system board after you remove the drivers while in "Safe Mode", re-startyour machine, then shut it down, install the device then restart your machine and load the appropriate drivers if needed.
by acedan
by @lberto
You have another HARDWARE device such as Modem or extra communication port or SCSI card that has the same address as the communication port that you computer has built in. To be exact we are talking about the printer port address.
If you just pressF1 (which I think you're doing) it will not let you configure neither your printer port or your new device)
To fix this is very simple,
Press DEL,it will take you to the BIOS Setup, then go to Advance, you should be able to see LPT1 and 3f8 next to it, you have to change the address, it will give you a couple more, just change it and it will probably change the IRQ too, maybe it will be IRQ5 instead of IRQ7 which is the one selected right now.
Sometimes is easier to change the addresses on the BIOS rather than the other hardware device you are installing now.
Good luck,
@lberto
by acedan
by acedan
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending