Discussion Locked

Connect a PDC Win2000 server to a T1.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How do I install a server to a existing T1 line and make it a PDC of it's own?
Basically the current setup is as follows:
We have a T1 line coming from our main office to the building. We want to put a new server as a PDC and connect it to the T1 line for access to the main office and the Internet. There are going to be at least 50 PCs running Win2000 Pro under this PDC. Should we order a server with 2 NICs? Do we need a router for anything? What kind of Hub(s) do you recommend? How about recommendations on Patch panel materials?

Any help much appreciated.

5 replies

by mckaytech

You could install two NIC cards in the server and use it as the router. If you do that, you will just need a CSU/DSU to provide the Ethernet interface to the T1. Alternately (and preferably in my opinion), you can use a router with a CSU module (or a separate router and CSU/DSU).

I do not recommend hubs at all any more, since switches are widely available at reasonable prices. I'm fond of Cisco products, but there is a price attached to them and there are certainly other switches out there that do a good job. HP has some very reasonably priced switches. With over 50 ports, you'll want to look at switches that are stackable so you can maintain full speed to all ports.

For patch panels, I use either Ortronics or Hubbell and use pre-made patch cables between the panel and the switch. It's very rare to have to go back and re-do anything on the panel when using these components in the first place.

paul

by shad626

Remember there are no PDC's in Windows 2000 Server all servers are equal domain controllers.

This discussion is closed to new replies.