Discussion Locked

Connect to Domain

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
Here is information on our network..
1. NT 4.0 Domain controller
2. 3 BDC's (NT 4.0)
3. Two locations and on different subnets
192.168.2.xxx and 10.0.39.xxx
255.255.255.0 255.255.255.192
4. PDC is at main location, and one BDC is at the remote location
5. Have a VPN tunnel established and the needed route statements are 'in place'
6. All computers are on the same domain.
7. Problem is at the remote location.
8. We are able to ping ANY computer by IP address, and by name.
9. Win98 workstations are connected fine and have no problems.
10. Problem: Setting up two Win2000 Pro workstations. They are on the same workgroup.
11. They can browse the network, see all computers, and ping any computer by IP or by Name12. These two computers are NOT able to join the domain.
13. When attempting to join, this message appears...
The following error occurred attempting to join the domain "domain": The specified domain either does not exist or could not be contacted.
14. I have tried different HOSTS and LMHOSTS files, but nothing will work.

I have tried the LMHOSTS file with the ..

192.168.2. "domainname \0x1c" #PRE #DOM:domainname

Using both the PDC and the BDC (at different times) Inboth cases, I came up with the same error.

NOTE: one time the error was different. It was indicating that the username and password for the Administrator were not correct. Re-typed, several times, would not recognize the username.

NOTE 2: There is another NT 4.0 server at the remote location. It is able to be a member of the domain (was added before the BDC was placed there). Problem seems to only be with the Win2K systems.

Any Suggestions?

9 replies

by rabbit_runner

Yes, the win2k clients were added, removed, and then added to the server-manager. This was done several times. Still had the same problem.

Do you have any other suggestions?

by rabbit_runner

Yes, WINS is working fine. We are able to ping the PDC by name and IP. This is really strange.

Do you have anyother suggestions?

by nettek

Does your WINS server have a Scope ID configured in TCP/IP protocol Properties? This can prevent a Win2K machine from joining an NT 4 domain. If so, try turning the Scope ID off.

by rabbit_runner

Sorry, this did not work. We checked the Scope, Wins, Lmhosts, Hosts, username, password, etc. Thus far, nothing will allow us to join the domain.

Thanks for you help

by ronnonf

2000 does not need WINS those it can use it in conjunction with DNS. What would happen if you built an NT machine and tried to join the domain with that machine?
Did you check the ip addresses? Are they within the correct scope? Do you have administrative permissions locally? When you want to join the domain are you entering a user id with Domain Admin permissions?
Answer all these questions and the solution should come to you.

by rabbit_runner

We have an NT 4.0 server at the remote site. It is able to join the domain. It has no problems at all. The Win2k, seems to have some type of communications problem. I can Ping by ip and name. I can browse the network and see all the computers. The Domain Administrator and password are used. Permissions is not an issue here.

It seems as if it is some type of NetBIOS problem. IP works fine. but the computer cannot authenticate to the domain. Even though the NT 4.0 server can.

Thanks for you help

This discussion is closed to new replies.