Discussion Locked

Connecting 1 PC to 2 different networks

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible to install two separate network cards on one PC? I need to connect a PC that is on our existing network to a new network that will allow monitoring of phone calls.

7 replies

by wgunne

It is possible to install 2 nic cards in a single computer. You will need to assign a seperate IP address to each card in its properties.

by steby

You can theoreticaly install up to four NICs in a PC running NT. When you install the cards and the TCP/IP stack, you can select each card and set up seperate IP addresses for each card. This process is called multihoming. NT will transmit on all cards if the IP's are on the same subnet. All cards will receive all messages (again if all cards are on the same subnet). Switchovers are not really done...transmissions go to all cards regardless of the state of the network. Receptions are handled the same way, all valid receptions are passed up the stack. When the IP's are on different subnets the answer depends on the destination IP. Does the message go thru a router? a gateway? Usually NT will try to send on the destinations' IP subnet. If this fails the message is sent on all cards. I hope that each card is on a physically seperated network. If both cards are on the same physical network, you are only protecting against NIC failures...a relatively rare event.

by ronnonf

Yes you can install and configure 2 NICs in one machine. Just be aware that there should not be any conflicting IRQs and each card should get a different ip.
The machine can only belong to one domain. The machine can belong to one while the user loggs into another.

This discussion is closed to new replies.