Discussion Locked

copied admin profile incorrectly

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I created a profile under the admin user and copied to other users. However, I copied the profile with the "permitted to use" setting set to "\administrator"
and had to change user permissions to local admin to enable users to run Outlook 2000. I would like to change permission on that profile so I can change user permissions back to Power User or User. HOw do I change permissions on profile without recopying profile? (BTW, removing users from admin group removes their power to run Outlook.)

2 replies

by umbral-echo

The "Permitted to Use" section of the "Copy To" feature you used does not change the permissions. You must perform both operations to allow a user to log on with the profile. The user must have the correct NTFS permissions and the user must have been granted the ability to use the profile with the "Permitted to Use" section.

The easiest way to do this is to copy the profile to the same location that you are copying from using the "Copy To" feature. This works fine and will not result in an error. Change the "Permitted to Use" section to the correct account or group. Then make sure that the NTFS permissions allow access.

by umbral-echo

I have used Outlook 2000 with no problems regardless of the user. However, initially Outlook 2000 requires configuration that a normal user does not have permission to do. The first time Outlook is run it should be run using the "Runas" command. Hold down the Shift key and right-click on the Outlook icon and it should appear in the menu. Use the administrator account to run Outlook for the first time, configure it and then the user will have no problems after that.

This discussion is closed to new replies.