Discussion Locked

Crazy Mouse

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My mouse will move up and down but not side to side.
I have checked for viruses, installed the latest video drivers, installed a known good mouse, reinstalled Win98SE...still no side to side movement. It is a PS2 mouse so I tried a serial mouse...same thing.
There are no conflicts in the device manager. I have not installed any new software. The power supply failed and I replaced that. Could the failed power supply have damaged the motherboard or chip? Why would this symptom happen with both PS2 and serial mice?
AMD K6-II 500, 64MB ram, Diamond SIII 540 AGP video, Win98SE.
Thanks for any help.

5 replies

by lucard

Try to install the mouse under a DOS enviroment. If it still doesn't work, then you have a defective motherboard and you should replace it. Good luck.

by shane

Same thing in Dos...guess the only thing left is to replace the mobo. The bad part is it's only about 2 months old.

by dmiles

The only way this could be a possibility is if their was a power surge at the time of the power supply failure and if I recollect there was a similar question,the problem sound like a electrical discharge that only damaged the circuit and the symtoms are getting worse,so try looking into a new motherboard.

by shane

Thanks for the answer, but it was connected to a good surge protector.

This discussion is closed to new replies.