Discussion Locked

Creating fault tolerant bootable floppy

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello There,

Can you help me on how to create a bootable floppy disk that can be used to start up my NT SERVER using the mirror partition in case the primary booting partition fails.

I am aware of the kb article Q113977 on this topic, but it simply refers one to the "Concept and Planning Guide" of my version of server which I dont seem to be able to find.

I have a licensed copy of Backoffice 4.0 from which i have installed NT 4.0 Server on an array of scsi disks and mirrored paratitions.

Thank you.

5 replies

by liquidcoolit

Have a look at kb Article Q119467 - for making an NT Boot disk. Then look at kb Article Q102873 for setting the boot.ini file that you place on the boot disk to point to your Mirrored Disk.

Cheers ....

by ceo_race

First and MOST IMPORTANT, format a floppy using the NT machine. If you format from dos or w98 it will not work. Then copy bootsect.dos, ntldr, boot.ini, ntdetect.com, ntbootdd.sys to your newly formatted floppy. Make sure you have the view all files set or you won't see these files. If you don't see bootsect.dos or ntbootdd.sys don't worry they don't always exist.

Now open your boot.ini from the floppy using notepad and change the line :"default=multi(0)disk(0)rdisk(0)partition(1)\winnt" to read "default=multi(0)disk(0)rdisk(1)partition(1)\winnt"

These numbers listed above are the defaults, if your numbers are different you still need to change the rdisk number to the new drive.

If you default line starts with scsi then replace the disk(0) with disk (1) or whatever the scsi id of the disk that is the mirrored is.

MOST IMPORTANT---TEST THE DISK AFTER YOU FINISH! Nothing worse than trying your disk when the failure occurs and finding it does not work.

This discussion is closed to new replies.