Discussion Locked

Dat drive cannot be accessed thro NT 4.0

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I am facing a problem in Compaq Proliant server that while booting it recognises the dat drive and the scsi but when it boots thro NT it does not detect any tape devices.It does not load the scsi driver als ie CPQfs32 driver.
Please help.

7 replies

by rcc

Hi
Check the event log for 4mmDAT device failure and post us the details. Are you sure you are using the right driver? Is the system set to automatically start the driver (Control Panel, Devices, 4mmDAT - Status Started, Startup-System) ?
In control pannel, go to your SCSI Adpaters and see if the DAT is visible as a device in the SCSI chain. Check if the DAT driver is loaded and started by using your TAPE Drive applet in the Control Panel.
Generally the 4mm built in drivers (NT) work. You may have to identify the brand and model of your tape drive and look for updates on the manufacturer site.
I hope this helps.
Regards,
Radu

by frobo

Hi ,

download the newst SSD(Compaq Support Software Disks 2.14a) from the Compaq Side and reinstall it on the Server. If you have the Compaq SmartStart CD (latest Release 4.90) you will find it under \CPQSUPSW\NTSSD\Setup.exe .
This happens sometimes, most if you have reinstalled the NT Service Pack you should reinstall the SSd after it (recommended by Compaq !).

Frobo

by cdeclercq

Does not load the SCSI? Are you running a SCSI boot disk? Do you have a ID conflict. What ID is the DAT drive?
Apply NT SP6 then the Compaq SSD (As already suggested) then go to the scsi adapters in the control panel and see if the scsi drive is found. is the drivers started.
Typically the scsi starts but the dat is not detected. If using a non-compaq dat, may need a driver other than the 4mmdat.sys if you are using compaq, then the SSD should apply the correct driver.

Can't do more without event log messages for cpqfs32 or 4mmdat drivers.

This discussion is closed to new replies.