Discussion Locked

DCOM: Unable to Communicate...

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a problem and would appreciate any help/advice from someone who may have experience of COM/DCOM objects on NT 4.

If you do, perhaps you would able to shed some light on the following error message being generated by NT

Event ID: 10009
Source: DCOM

DCOM was unable to communicate with the computer using any configured protocols.

We are unable to locate much information on this error message from the web, technet or the microsoft web site. If you have any experience of this type of problem please let me know. We have checked all the obvious things but to no avail.

Running NT 4.0 SP4 + NTSE over 10Mbps LAN.

5 replies

by ann777

Is this on an IBM computer? Does it always report non-communication with the same server or other servers?

Two things here:
Verify the protocols you are runnign.
Diagnose/troubleshoot the Network Adapters.

by duwaned

Hi.

Have you seen the following TechNet article: Q245197

This article details your error message exactly.

To see this article, go to http://www.microsoft.com and do a search for the article number.

I hope this helps.
Regards.
Duwane

This discussion is closed to new replies.