4 replies
by sckrem Accepted solution
by seanferd Accepted solution
Look up the beep codes for you exact BIOS. What you were told may be right, or it may not be.
If it is a RAM problem, try gently cleaning the contacts on the memory sticks with a soft rubber eraser. Do not touch the contact with your fingers. Reseat.
You can also try looking in BIOS setup for a diagnostic to run on the machine, or any error messages.
You can also test RAM with
http://oca.microsoft.com/en/windiag.asp
http://www.memtest.org/
http://www.memtest86.com/
http://hcidesign.com/memtest/
by oh smeg Accepted solution
Even a high end PS Tester isn't that accurate and at best only tests in a No Load condition so the PS can pass that test but still not be working.
However I would remove all of the RAM and turn on. If the system keeps running but beeping at you fit 1 RAM Module and try again. If it doesn't keep running fit a new PS and try again.
If it still doesn't keep running replace the M'Board.
Col
by prrethish Accepted solution
Hai friend try this
Remove u r processor & fix it back
remove all u r smps connections like to hard disk Floppy disk Cdrom and try to make on u r pc
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending