Discussion Locked

DHCP on DC Machine

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have installed DHCP server on Windows 2000 DC Machine it also has DNS server installed.
DHCP server always giving a warning message
"The DHCP service failed to initialize its global parameters.
The following error occurred %%0"
and then DHCP clients PC giving IP conflict message and disabling IP protocol. Then i am looking aktive releases and i see lots off bad_address lines for my scobe .
If you have a comment i will be happy to hear from you.
Thanks,
Bayram.

3 replies

by joiner

Bayram,
It sounds as though you have a problem with your DHCP server not being authorized in Active Directory. If your Windows 2000 DHCP server hasn't been authorized in AD, it will stop and report an error during startup. To correct this, open up DHCP, and right click the DHCP tab and choose manage authorized servers. That will give you the option to authorize your server.

This might be one of the problems you're encountering.

Hope it helps,
Glenn

by bguldibi

My server has 2 ethernets one have a local IP subnet 172.16.10.1 and the other has 3 IP 192.168.1.2 and 2 registered IP addresses temporarly until firewall test has finished. 2 hubs connected each other by a cross cable for PCs has registered IP buti have just registered 172.16.10.1 and my scobe is 172.16.1.1-254 subnet 255.255.0.0
I have also registered all IPs now and will try tomorrow.
Thanks,
Bayram.

by map6551

This discussion is closed to new replies.