Discussion Locked

Dial in access can't get Internet Access

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have windows advanced server set up and running our network. Routing and ras is setup. 2 of our users have access to dial in to the network and log on. When they do, even though they have administrative rights, they don't have access to our other 2 subnets of the same domain and they can't get Internet access. I have also given them static IPs and plugged in our DNS #. Nothing. What must I do to get them full access to everything.

Thanks
Merv

9 replies

by beermonster

Do the remote machines have, as a gateway address, the gateway for the subnet that the server is on (IE the same gateway that the server uses) ?

by stillatit

1. Your dial-in must be set to give users access to the network, not just the computer.

2. On the user's side, in the dial-up networking entry, tcp/ip properties, they need to either have the "Use default gateway on remote server" box checked (strongly recommended), or they need explicit ROUTE commands run to establish routes to items on the other side of the dial-up. In the latter case, you will need to specify the dial-up box as the default route in any case, or internet traffic will not go there.

3. Presumably your server CAN get to the other segments and to the internet, but check your static routes in RRAS admin to make sure that there is a default route pointing to the right place.

4. By the way, this is a routing issue, not a rights issue. Admin rights should have nothing to do with this.

Good luck.

by whatme?

Done all that. Network works fine. I can dial in, log onto network but just can't get out onto the Internet. Worked fine in NT4 but not in 2000 for some reason
Merv

by rojiru

Your problem is most likely in type of server dialing into being not selected properly on the dialup pc's either ppp or slip. Also, you need to check ppp settings for each pc dialing in. There are some settings that will not work in some instances (ie Enable LCP extensions, Enable software compression etc) Check these things on the diapup pc's. I know very well how frustrating it is. I have done many dialup setups to workstation as well as server. Anyone of these settings can allow connection, but no INet access.

Also, be sure that the dialup pc's are using the correct domain/workgroup name.

I have not as of yet been able to get network access on a dialup using ppp, though it is not a priority.

Hopefully this will help get youin the right direction.

by whatme?

I tried each one. Can access the network but still can't get out to the Internet.

This discussion is closed to new replies.