Discussion Locked

Dial up conflict with LAN in NT4

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I keep LAN and dial up working at the same time? Two discrete connections: PPP receives dynamic IP from ISP and LAN network browsing halts during entire dial up session then immediately upon disconnect LAN resumes with complete functionality(Printing, browsing,surfing etc). Bindings? DNS? LMHOSTS? Thanks.

8 replies

by launenhaft

you could try adding something like this to your startup

ROUTE ADD xxx.x.x.x mask xxx.x.x.x xx.x.x.x
^destination ^mask ^gateway

by james_randy

Keep them both plugged in at the same time, and they should work at the same time. That is, of course, unless some cretin comes along and unplugs something.

This discussion is closed to new replies.