Discussion Locked

Dial-up Connection Issue

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have been totally unable to setup dial-in to my NT 4 server... The server answers and even seems to authenticate the user but the user can't "see" anything or even "find" any server shares. Even if I sign in as the administrator, I can't "see" anything. Funny thing is that I am able to browse the Internet from the local, dialed in PC which means I'm going thru the dialed connection thru to the server and out the server's ISDN connection. ??? what am I missing...

4 replies

by clt-it_tech

Wanted to add that this is a very simple NT4 server with 20 workstations all using TCP/IP private network IP addresses (ie: 192.168.0.25), a NetGear ISDN router and one 10/100 hub. Thanks,,,-dk

by dcassat

You're missing the browse list. Either you do not have the right workgroup on the identification tab of the dialed-in computer or perhaps you should make sure that WINS is enabled on the workstation. Using DHCP properly configured to supply the right WINS server address is the best way to handle this. You may verify this by mapping a drive to the server from the DOS prompt. Net use g: \\server\sharename should attach to the server even though it does not show up in network neighborhood. Inaddition you will have been overall success with RAS if yo umake sure that TCP/IP is the first binding listed on all protocols and cards installed (binding order). Good Luck.

This discussion is closed to new replies.