Discussion Locked

Dial-up Networking Win98 to WinNT 4.0

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am setting up a win98 machine to use Dial-up Networking into my companies winNT 4.0 server. I am able to connect to the server with my login and password. When I try to use network neighborhood to see the drives on the server I can't see the server I have dialed into. Can someone clue me in on what I might be doing wrong?

13 replies

by howarde

What happens if from start--> run you type \\? If this brings up the shares on the server (hidden shares like C$ will not show up). If this shows resources on the NT Box, then the problem is the browse list which can take up to 15 minutes to update. If this doesn't work, then the problem is somewhere with the server service.

by nettek

You aren't very specific in your question. Are you running RAS or VPN? I will assume you are using TCP/IP and not NetBEUI. Are you using WINS? If you are using WINS, try manually inputting the WINS server addresses under the DUN settings. If you are not running WINS, try adding an LMHOSTS file on the client.

by allan

If your logging in with a password, is this a dialup password or your domain Login ?
Make sure you have your network properties set to "Log in to an NT Domain" with the domain name specified.

by mike

It's a common problem with ras the poor performance of ras cause the explore to time out. go to a command prompt and type in
"net view \\ipaddressoftheserver and it should list the shares, then use the "net use x: \\ipaddressoftheserver\sharename" to map a drive this works flawlessly, then create a batch file on the desktop to run after ras is connected
Good Luck
mike

by baziite

Go to Start menu / Find / Computer and type the IP address of the server and try to find it . If you can find it it will appear in the Network Neighborhood . Also if you are indeed using TCP /IP Protocol I would recommend that you switch to NETBEUI or NWLINK because Win 98 is messy when it comes to browsing resourses on a Win NT TCP/IP network .

by kirkhuyser

Right-click Network Neigborhood, and select Properties. At a minimum, you should have TCP/IP Protocol and Client for Microsoft Networks installed. You should also see TCP/IP -> Dial-Up Adapter to prove the binding between TCP/IP and your Dial-Up adapter. Contrary to what someone else said, TCP/IP is the best protocol to use. You don't need NetBEUI. Microsoft runs NetBIOS over TCP/IP (NBT), and it works great.

Next, click the Identification tab. Make sure the Workgroup name is EXACTLY the same as the Domain Name of the system into which you are dialing. THIS IS VERY IMPORTANT! In fact, if you've done everything else I suggest here, I would bet this is the one thing that is preventing you from seeing your company's resources in your network neighborhood. You'll have to reboot after changing the Workgroup name.

In your Dial-Up "connectoid" for dialing in to your company, select Properties by right-clicking it. Select the Server Types tab and make sure PPP is the chosen type. Check the "Log on to network" box. Check "Enable software compression." Check TCP/IP box (I recommend leaving the others unchecked, unless your company's network administrator tells you otherwise). Click the TCP/IP Settings button. Select "Server assigned IP address" button. Select "Server assigned name server addresses." Check "Use IP header compression" and "Use default gateway on remote network." Click OK, OK.

This should do it for you. If you don't see other computers in your Network Neighborhood, you will eventually. You can go the the Start | Run command box, and type "\\computername" (without the quotes) to browse the resources of some computer on the company network named "computername" (assuming you have the proper permissions). Wait for a response of some sort.

This discussion is closed to new replies.