Discussion Locked

DirectX 8.0 and ATI Rage Pro Video card

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Just recently I bought the game Myst III: Exile. During the installation, I installed DirectX 8.0 on my computer. When the computer restarted, the monitor stopped working, and when I turned the monitor off and back on the screen was very distorted. To fix this, I had to go into safe mode and reset my video settings. I am currently stuck with using 256 colors, instead of 16 bit colors. My question is: Does anyone know how to get my colors back to 16 bit, or how to uninstall DirectX 8.0 and go back to DirectX 7.0? Thanks in advance.

8 replies

by fossil

I had a similar experience. This will not be too helpful, but rather, just sharing my experience. I had **BAD** DX*.0 experiences. IMHO, DX 8.0 s**ks, and based on newsgroups, I have a lot of company. MS KB says no uninstall is available for DX8.0. In reading the newsgroups several methods were proposed. After 5 days and countless hours, I just gave up. I backed up my personal files to another drive, wiped my C: drive and reinstalled the OS and all my software. MS tries to make you beilieve that DX7 isn't available any more, but I found it on their site at http://www.microsoft.com/downloads/release.asp?ReleaseID=16819
Good luck.

by fossil

I forgot to mention that my experience involved a Dell PIII/600 w/ ATI Rage 3D OEM graphics. I did **NOT** have Myst installed. My DX8.0 was a "self-inflicted", direct install of DX and not part of an install of other software.

by richard_barsby

Hi it sounds like the refresh rate was to high this should not happen if you have the correct monitor type installed, you should then be able to set the correct resolution a colour depth ie 16bit.

Hope this helps

Rich

by gmscne

YEs, it does sound like your refresh rate was incorrect. You can change this. Go to Start, then Run, and put in DXDIAG. On the last tab, marked "More Help", there is a botton marked "Override" to set your own refresh rate. Check your monitor documentation to get the maximum acceptable setting but you can use a low one like 60 or 72 if you know that it works. Hope this helps.

This discussion is closed to new replies.