Discussion Locked

Disableing Onboard Video

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an HP Pavillion 8750c and need to disable the onboard video to install a pci video board.
Anyone have any solutions?

15 replies

by homer simpson instructor at large

Have you tried going into Device Manager and disabling the video from there. I've always used that for disabling onboard video, so you can put a higher capacity video card into a system...what OS are you using?

by mjh...

HP has a propriatary driver and it is not that easy. Onboard video keeps coming back on top of pci video. WIN98SE.

by dmiles

Boot the computer,and dwhen you see the Startup screen,press the key to open CMOS Panel to Bios
On the panel configuration locate the Video controller using the arrow keys,then press the Enter key this will show a screen,highlight video and press enter and it should show Enable or Disable use arrow key to select and press Enter save changes and exit

by thechas

You are best off doing a combination of all 3 previous answers.

First, you want to remove the current display adapter from within device manager. Windows always handles new devices better if you tell it that you are removing the old device first.

Then, check add/remove programs and remove any programs that are specific to the video system.

Shut down the system.
Check your manual, or HPs web site for instructions on how to disable the on-board video. It may take a combination of jumper and BIOS settings.

Check the documentation for the new video card for any specific bios settings required.
Install the new card.

Boot the system and go into setup.
On the advanced configurations, you want to make sure that the first display device is set to PCI instead of AGP. (assuming that your new card is a PCI card)

Save the settings, and exit.
Install the driver for the new card per the card mfg recomendations.

You may need to update the chipset drivers for the MB, and DirectX to have everything work.

by mdl3

You can disable your onboard video, you can't remove it. Go to device manager highlight display adapter,rigth click on it and go to properties than look for disable this device and disable it, you will see a disable mark on the device in device manager.
than turn your computer off and install the new video adapter, turn your computer on and windows will find your new device and it will ask you for the driver,click select from the list, and than click on have a disk and insert the disk, and lastly point to where the driver is located (fdd,cdrom,selected location) and follow the on screean instructions.

by mic3

has no jumpers onboard to disable graphics intel810 needs to be disabled in the device manager go in the bios change video boot type to pci.
cheers tech support for hp

This discussion is closed to new replies.