Discussion Locked

Disk

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I have a 40gig drive connected as a slave to my master(hard drive).I have a nt4.0 computer.For some reason I can not see the full 40gig, I could only see 32gig of it.I tried the disk administrator in nt, fdisk,I even tried using partition magic.It is a ultra-ata 100 western digital.I also lowered the ata to 66 and still the same result.Is there any reason why I cannot see the full 40gig and is there a way to see it.Any help would be appreciated.Thank's in advance....

9 replies

by thomas.white

Is it 32Gb after format or does it show up in the bios as 32 if it is 32 after format it is because of something called slack, the bigger the drive the more slack 10 to 15 % on those large drives is normal. Chaeck the bios and see what it is detecting if it is saying 32 then the bios may not allow drives over 32 try and set the settings manually in the bios and see if it works.

by mm212

twhite's answer is correct, but there's another spot where space disappears. That is in the definition of a Gig.

In technical terms, 1k is 1024 bytes, 1 meg is 1024, 1 gig is 1024 meg. The problem is the marketing department of drive manufacturers. If you read the fine print on the box of a hard drive, most likely you'll find that they define a gigabyte as 1,000,000,000 bytes. If you do the math, you find that a gig is actually 1,073,741,824 bytes. That means that a drive actually holds only93% of what the manufacturer figures, which comes to 37.25 gigabytes on their 40 gig drive. Once the drive is partitioned and formatted, that gets you down closer to the ballpark you mentioned.

by gmac

I would recommend you verify you have the latest BIOS installed for your motherboard. Does the BIOS recognize the 40 GB?

This discussion is closed to new replies.