Click Start, Run and type cmd and press Enter. Type the following commands and press Enter after each one.
Fsutil dirty query C:
If C: is not the drive you're checking, then you'll need to change that value in the command. When you execute this command, the result should tell you if the drive is dirty. Which it most likely is if Check Disk is running every time you start Windows.
At this point, you'll use the Chkntfs command to disable the Check Disk operation for the next startup. Type:
Chkntfs /x C:
Again, if you're not troubleshooting the C: drive, change the value in the command. When you execute the command, the result should tell you that the file system is NTFS.
Now, close the Command Prompt and restart Windows. Hopefully, Check Disk won't run and you'll boot directly into Windows.
However, Check Disk does run, don't despair. Let Windows boot and then open a Command Prompt window. Now, run Check Disk in full repair mode by entering:
Chkdsk /f /r C:
If you're not troubleshooting the C: drive, change the value in the command.
http://technet.microsoft.com/en-us/sysinternals/bb897447.aspx