Discussion Locked

"Disk not formatted" Error

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Pentium 233, Win98SE, Award 4.51PG bios dated 1997

Floppy drive works fine when I boot up in DOS mode, but when I boot into Windows, any floppy I insert in the drive comes up with the message "Disk in drive A is not formatted, do you wish to format it now?"

1) The disk is actually already formatted and has data.

2) If I answer Yes to the format question, the disk does not get formatted, instead I get the invalid track 0 error.

3) I can format a floppy perfectly in DOS (DOS mode boot, not DOS window in Windows)

Any help would be appreciated. Thanks.

MKD

13 replies

by dmiles

It may be a problem with the Floppy disk Controller,open device manager and select the floppy controller and then click remove
Now open the control panel and select the Add/New hardware and let windows detect the floppy controller,now if this does not work you may have a floppy gone bad and needs to be replaced

by tilt

Thanks Soulrider, but it did not work. And as for the floppy gone bad, not possible because the floppy works perfectly in DOS. I can format, read, write, do anything!

And by the way, before posting the problem here i swapped three floppy drives(one brand new, two cannibalized from working machines just to eliminate possibilities) and also swapped two sets of interface cables, every one of them performed identically - works in DOS, not in Windows!

Thanks again.

by ann777

Windows is the problem here... the fact that everything works in dos means that windows has a problem,

I suggestthat you go to device manager and remove the floppy disk drive. Save and reboot. Let windows refind and reload the drivers for thefloppy drive. You should be fine thereafter.

by tilt

Thanks Anna, it did not work. Kindly see the reply I gave Soulrider.

Thanks.

by timthetoolman

Hi,

...and as a third opinion, I'd be suspecting the drive itself. If you can try another one, then do so.

You say you can format under DOS but can you successfully write to it and read back from it? DOS is a bit dumb and may not spot a hardware problem.

Cheers,
Tim.

by tilt

Thanks TimTheToolman. If you read the reply I gave Soulrider you will notice I already tried what you suggest. I even tried different cables.

Thanks again.

by tilt

No luck Tim, and by the way, this was a completely new installation, freshly partitioned hard disk and so on. Still, I ran a scan and it came out clean. Latest version of Norton Anticirus and latest virus definitions.

Cheers

by isys

How many copies of COMMAND.COM are on your system? Do they all have the same date/time stamp and are they all the same size? Try booting to a DOS prompt and examine your path. Copy the COMMAND.COM file from that location to the other places it resides.

by drdmc

I think Anna is right. Your controller has to be working for DOS to use it. You have eliminated drive or cable problems. You may have corrupted driver files or cross-linked files present. They may show up with system file checker. If not, you may just reinstall 98 on top of itself. This is a weird one. Good luck!

This discussion is closed to new replies.