Discussion Locked

Dos

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am getting a low memory error when I try to run defrag on a dos 6.22 machine. I have plenty of memory 600kb. Why could this be happening?

7 replies

by grump

How full is the hard drive.. Defrag has to move data around and it don't like to be crowded out of HD space..

Also if you load some device drivers and memory manager, this could possible be you problem.. Try booting clean and then running DEFRAG.. CLEAN BOOT IN DOS not loading any thing except COMMAND.COM
Hope this helps... GOOD LUCK!

by @lberto

Defrag uses the low memory to store information while it is defragmenting your HDD, your probably are loading so many drivers or resident programs that are using too much of your "low memory", remember that it doesn't matter how much memory you have(only on DOS), it will always try to load its program into the base memory (the 640K base memory). What I suggest you to do is either press F5 while your are booting so you skip all the drivers so you can have as much free low memory as posible or just boot from a floppy disk with loading any driver.
Another option is try to load as much drivers as posible into the upper memory, using commands like devicehigh on config.sys and so on.
I Hope it helps, good luck,

@lberto

by Member 35772270

Edit your config.sys file on the boot disk.
Enter the following lines

device=himem.sys
device=emm386.exe
doshigh,umb

do not load anything in the autoexec.bat file.

This discussion is closed to new replies.