Discussion Locked

Drive letter assignment

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a old 486 that i want to use as a proxy server it has win 98. This is the problem I have a 20 gig scsi harddrive that was C, Then for an experiment I added a 2 gig Ide drive. Now typically the Ide should of become D, it did not the scsi became D. Is there a way in windows and not bios that I can redirect the drive letter assignment?

Respectfully

Ed earchacki@home.com

9 replies

by bob 10

I could be wrong , but i don't think you can change it. Here is what i think is going on. The Ide is being checked first at boot-up, how is the SCSI drive attatched to the system, does the MOBO have a built in SCSI controler or are you using a Plug in controller into a slot? If the SCSI controller is pluged into an expansion slot than the Bios will see it last and assighn the drive letter accordingly, thats why the IDE took C , Bios sees the IDE controller first cause it's on the MOBO and First in line through Bios.

by dmiles

Basically the bios and configuration of a IDE and SCSI,the IDE will be the boot drive,for SCSI to be the boot drive it will need to be configured as SCSI ID 0,the number is assigned through a jumper or DIP switch block.

by phy

Your BIOS *might* support boot from SCSI option. You could also try changing the partition (FDISK) on the 2gig to an extended DOS as opposed to primary DOS, that way the drive letter assignment may work differently...but don't quote me on that ;-)

by cdobbin

I'm pretty certain that your BIOS would have to support booting from SCSI device in order to do this. With your old 486 I can't think of any way around it.(I could be wrong).
BTW setting it to ID 0 would make no difference, and you can't make an extended prtition without a primary partition.

This discussion is closed to new replies.