Windows Forum

Ask something
Discussion Locked

"Drive not ready"

0 helpful
3 replies

by azbrushape

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am having trouble "reaching" a WD Enterprise WDE9100 ultra fast wide SCSI 3 HDD. It only returns the error msg, "drive not ready". What is wrong,(my fault?)? All pin connectors are properly placed, I believe, altho I do NOT have a pin connections read-out. It is one of two I recently received, and after buying a new controllor card, the other is operating normally.
can anyone suggest an answer? thanks.
AZBRUSHAPE@AOL.COM

3 replies

by azbrushape

I agree. The drive has run VERY hot. The same procedures were used to put both the drives in service, but this one did not come up.

This discussion is closed to new replies.